YZF18-30 18w Fan Motor Aluminum Wire Copper Wire

Foot mounting: Track dimension 26mm or 18 mm possible

Type of protection: IP42 or IP44

Electrical connection: Jacketed cable 3x0.5 m㎡ with brass lead tips

Product conforming to standard: CE

Approvals: VDE( except 3W),CCC

Valid for all design:

—Material: Housing made of die-cast aluminium

Stator pack: coated in black

—Direction of air flow: "S"or "B"(depending on axial impeller used)

—Direction of rotation: clockwise(or counterclockwise), seen on shaft end

—Insulation class: B

—Mounting position: Any, preferrably horizontal

—Condensate discharges: None

—Mode of operation: Continuous operation (S1)

—Bearings: self-adjusting calotte sleeve bearing(mean service life of 30,000 hours in horizontal installations position)

—Motor protection: impedance switched ( combination D-H)

—Mounting: guard grille and wall ring are mounted onto the protruding thread ends of theA side.The Q-motor can also be screwed on via the mounting flanges (integrated in the bearing shields).

—Axial impeller mounting: Mounted to the motor shaft using a plastic adapter with pulling peg and an M4 screw(combination A-D) OR M5 (combination E-H) screw.

To optimize motors performance, we can also supply our clients with a variety of brackets, rings, fan blades, guard grill,etc.